AD820AR-REEL7 Datasheets | Linear - OP Amps, Buffer Amps J-FET Amplifier 1 Circuit Rail-to-Rail 8-SOIC
By apogeeweb,
AD820AR-REEL7, AD820AR-REEL7 Datasheet,AD820AR-REEL7 PDF,Analog Devices Inc.
Descriptions
Op Amp Single Precision Amplifier R-R O/P ±18V/36V 8-Pin SOIC N T/R:Verical
Operational Amplifier Single General Purpose Rail to Rail Output ±18V/36V 8-Pin SOIC N Tape and Reel:Jameco
Ic,Operational Amplifier,Single,Bipolar/Jfet,Sop,8Pin,Plastic:Newark
The AD820 is a precision, low power FET input op amp that can operate from a single supply of 5 V to 36 V, or dual supplies of ±2.5 V to ±18 V. It has true single-supply capability, with an input voltage range extending below the negative rail, allowing the AD820 to accommodate input signals below ground in the single-supply mode. Output voltage swing extends to within 10 mV of each rail, providing the maximum output dynamic range. Offset voltage of 800 µV maximum, offset voltage drift of 2 µV/°C, typical input bias currents below 25 pA, and low input voltage noise provide dc precision with source impedances up to 1 GO. 1.8 MHz unity gain bandwidth, -93 dB THD at 10 kHz, and 3 V/µs slew rate are provided for a low supply current of 800 µA. The AD820 drives up to 350 pF of direct capacitive load and provides a minimum output current of 15 mA. This allows the amplifier to handle a wide range of load conditions. This combination of ac and dc performance, plus the outstanding load drive capability, results in an exceptionally versatile amplifier for the single-supply user. The AD820 is available in two performance grades. The A and B grades are rated over the industrial temperature range of -40°C to +85°C. The AD820 is offered in three 8-lead package options: plastic DIP (PDIP), surface mount (SOIC) and (MSOP). Applications Battery-powered precision instrumentation Photodiode preamps Active filters 12-bit to 14-bit data acquisition systems Medical instrumentation Low power references and regulators Data Sheet, Rev. F, 11/08:Analog Devices