The SN74LVC2G74DCUR is a single Positive-edge-triggered D-type Flip-flop with clear and preset. A low level at the preset (PRE) or clear (CLR) input sets or resets the outputs, regardless of the levels of the other inputs. When PRE and CLR are inactive (high), data at the data (D) input meeting the setup time requirements is transferred to the outputs on the positive-going edge of the clock pulse. Clock triggering occurs at a voltage level and is not related directly to the rise time of the clock pulse. Following the hold-time interval, data at the D-input can be changed without affecting the levels at the outputs.
Store state information for later use by using the Texas Instruments SN74LVC2G74DCUTE4 flip flop device. It has a differential output signal. This flip flop has an operating temperature range of -40 °C to 125 °C. This product will be shipped in tape and reel packaging so that components can be mounted effectively. This inverting/non-inverting device has a typical operating supply voltage of 1.8|2.5|3.3|5 V. Its minimum operating supply voltage of 1.65 V, while its maximum is 5.5 V. It has 1 channels per chip.
The NC7SZ74K8X is a TinyLogic® single, D-type, CMOS Flip-Flop IC with preset and clear. This is fabricated with advanced CMOS technology to achieve ultra high speed with high output drive, while maintaining low static power dissipation over a very broad VCC. The inputs and outputs are high impedance when VCC is 0V. Independent of VCC operating voltage. The signal level applied to the D input is transferred to the Q output during the positive-going transition of the CLK pulse.