MSP430G2553IPW28 vs MSP430G2553IPW28R vs MSP430G2153IPW28 Comparison

The MSP430G2553IPW28 is a 16-bit ultra-low-power Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1µs. The device configurations with two 16-bit timers, 10-bit A/D converter, a versatile analog comparator, built-in communication capability using the universal serial communication interface and 24 general-purpose I/O pins. This device operates at a maximum frequency of 16MHz.

.

16-bit RISC architecture, 62.5ns instruction cycle time

.

Internal frequencies up to 16MHz with four calibrated frequencies

.

Internal very-low-power low-frequency oscillator

.

32kHz Crystal

.

External digital clock source

.

Two 16-bit Timer_A with 3 Capture/Compare registers

.

Up to 24 Capacitive-touch enabled I/O pins

.

Enhanced UART supporting auto baudrate detection (LIN)

.

IrDA Encoder and decoder

.

Synchronous SPI

.

On-chip comparator for analog signal compare function or slope ADC

.

10-bit 200ksps ADC with internal reference, sample-and-hold and autoscan

.

Brownout detector

.

Serial on-board programming

.

No external programming voltage needed

.

Programmable code protection by security fuse

.

On-chip emulation logic with spy-bi-wire interface

.

230µA at 1MHz, 2.2V Active mode (AM) power consumption

The MSP430G2553IPW28R is an ultra-low-power Mixed-signal Microcontroller consists of several device features different sets of peripherals targeted for various applications. The architecture, combined with five low-power modes, is optimized to achieve extended battery life in portable measurement applications. The device features a powerful 16-bit RISC CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1µs. This ultra-low-power mixed signal microcontroller with built-in 16-bit timers, up to 24 I/O capacitive-touch enabled pins, a versatile analogue comparator and built-in communication capability using the universal serial communication interface. In addition this family has a 10-bit analogue-to-digital (A/D) converter. Serial on-board programming, no external programming voltage needed, programmable code protection by security fuse.

.

Brownout detector

.

On-chip emulation logic with SPY-BI-wire interface

.

32kHz Crystal

.

External digital clock source

.

Two 16-bit Timer_A with three capture/compare registers

.

Up to 24 capacitive-touch enabled I/O pins

.

Universal serial communication interface (USCI)

.

On-chip comparator for analogue signal compare function or slope analogue-to-digital conversion

.

10-bit 200ksps Analogue-to-digital converter with internal reference, sample-and-hold and AUTOSCAN

.

Green product and no Sb/Br

MSP430 MSP430G2xx Microcontroller IC 16-Bit 16MHz 1KB (1K x 8) FLASH 28-TSSOP