MSP430F247TPM vs MSP430F247TPMR Comparison

The MSP430F247TPM is a 16-bit ultra-low-power Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1µs. The device configurations with two 16-bit timers, 12-bit A/D converter, a comparator, a hardware multiplier, four universal serial communication interface (USCI) modules and 48 general-purpose I/O pins. This device operates at a maximum frequency of 16MHz.

.

16-bit RISC architecture, 62.5ns instruction cycle time

.

Internal frequencies up to 16MHz with four calibrated frequencies to ±1%

.

Internal very-low-power low-frequency oscillator

.

32kHz Crystal

.

Resonator clock

.

External digital clock source

.

External resistor

.

12-bit ADC with internal reference, sample-and-hold and autoscan feature

.

16-bit Timer_A with 3 Capture/Compare registers

.

16-bit Timer_B with 7 Capture/Compare registers

.

Enhanced UART supporting auto-baudrate detection

.

IrDA Encoder and decoder

.

Synchronous SPI

.

On-chip comparator

.

Supply voltage supervisor/monitor with programmable level detection

.

Brownout detector

.

Bootstrap loader

.

Serial on-board programming

.

No external programming voltage needed

.

Programmable code protection by security fuse

The MSP430F247TPMR is a 16-bit ultra-low-power Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1µs. The device configurations with two 16-bit timers, 12-bit A/D converter, a comparator, a hardware multiplier, four universal serial communication interface (USCI) modules and 48 general-purpose I/O pins. This device operates at a maximum frequency of 16MHz.

.

16-bit RISC architecture, 62.5ns instruction cycle time

.

Internal frequencies up to 16MHz with four calibrated frequencies to ±1%

.

Internal very-low-power low-frequency oscillator

.

32kHz Crystal

.

Resonator clock

.

External digital clock source

.

External resistor

.

12-bit ADC with internal reference, sample-and-hold and autoscan feature

.

16-bit Timer_A with 3 Capture/Compare registers

.

16-bit Timer_B with 7 Capture/Compare registers

.

Enhanced UART supporting auto-baudrate detection

.

IrDA Encoder and decoder

.

Synchronous SPI

.

On-chip comparator

.

Supply voltage supervisor/monitor with programmable level detection

.

Brownout detector

.

Bootstrap loader

.

Serial on-board programming

.

No external programming voltage needed

.

Programmable code protection by security fuse